Kit #7: Up to 200m3 – VK Plastic In Line Underfloor Kit

Motor Capacity: 930 m3/hr (258.33 l/s)
Motor Type: Plastic Centrifugal
Kit Includes:
1x VK Plastic 200 In Line Fan(EXVUVP200) Click to view fan Specs(includes installed lead & plug connected to high speed, which will need to be removed if purchasing additional speed controller accessory and hard wired instead)
1x 6m of 200mm duct(EDNU2006MF)
2x 6m of 150mm duct(EDNU1506MF)
2x Cone Vents(EVVUMC150) Click to view vent Specs
1x BTO 200X150X150(EAB30866F)
1X 200-150 Reducer(EAVUPR1)
1x External Wall Vent(EVVUFS150)
1x 24hour Timer(EABUT24) (The timer is plugged into a standard power point)
1x Flex & Plug(EALEADL21MB) (The fan is then plugged into the timer)
1x Roll on hanging tape(EATAPEH) (allows ducting to hang from joists)
1x Roll of duct tape(EATAPED) (allows secure connection of the system)
View full technical specs further down the page

Some buildings have very little subfloor ventilation. Inadequate underfloor ventilation can lead to an accumulation of moisture in the sub floor. This in turn can cause structural and health problems for the home and it’s occupants.

The most common reason for inadequate under floor ventilation is that there not enough vents, or they are too small for the size and layout of building. Building extensions, building location and soil type can all contribute to problems in the subfloor.

This underfloor kit is specifically designed for areas of up to 200 cubic meters.